LK201 C200H PDF

Product category: PLCs – Omron – C – Omron CH-LK (CHLK) This unit is fully tested prior to. Q: Can CH-LKV1 Host Link Unit be used with CS1-series Programmable Controllers?. CH Units that use the CPU bus, SYSMAC LINK Unit, CHW-SLK23/24 ( wired) CHW-SLK13/14 (optical). Controller Link Unit, CHW-CLK21 (wired ).

Author: Yorr Tygohn
Country: Nicaragua
Language: English (Spanish)
Genre: Education
Published (Last): 18 February 2012
Pages: 494
PDF File Size: 7.16 Mb
ePub File Size: 20.76 Mb
ISBN: 342-8-60375-707-6
Downloads: 70299
Price: Free* [*Free Regsitration Required]
Uploader: Samushicage

Posted 20 Nov On the older ones, it was only intended for the hand held programmer. On the CPU, led “run” is green. Posted 13 Nov edited.

C Series Host Link Units. Then the PLC cannot connect to Pc. If this is a 1 to 1 connection between the PC and the PLC then this is probably correct but not guaranteed. The dip witches in the host link are correct but still not connect.

In any case, look here: This is 2c00h node address.

Omron C500CN221EU Programming Cable, For Use With C200H-LK201 PLC, 6 ft

It’s on page 9 in the manual. Posted 15 Nov I have blown internal circuit board fuses on some of the older CH’s by trying to use that port. C2200hthat Data will have to be reentered into the appropriate locations. The DIP switch front are 0;0;5;2 back are off;off;on;off;0v Please help me!

  ADHYATHMA RAMAYANAM MALAYALAM PDF

By the way, can you tell me the different between lkV1 and lk? Can I move the host link to other slot of BB? Edited 15 Llk201 by sokhanh. Welcome to the Forum! Posted 22 Nov Remove all the modules from the rack and try the Host Link in another slot.

Omron CH-LK (CHLK) – Axdos AB | PLCSWEDEN | Automation Spare Parts

The restriction is strictly mechanical. Edited 16 Nov by sokhanh. I would still think you should see the RCV light.

If possible, which cable I have to use? I have tried with an ch-lkv1 but everything is the same. Register a new account. You need to be a member in order to c020h a comment.

I also tried with this cable LK Coputer Started by sokhanh13 Nov Posted 14 Nov edited. Lk2011 is basically the same as the rack mounted unit you have. This means you cannot use the small peripheral port for anything other than a hand held programmer. I have replaced ch-lkv1 by ch-lk and everything is the same. Posted 16 Nov edited. Be careful what you plug into it. The long port at the bottom is for a 3G2A6-LK The 25 pin connector would run into the bottom of those peripheral units if you used these slots.

  BURDA & WYPLOSZ MACROECONOMICS 5E PDF

The same physical issues occur with high density cards lk21 cables coming out the top.

Help me with c200h-lk201

The PLC configuration does not matter. If it is not blinking then you have a bad connection. This may or may not be an issue if they are mismatched I have checked the cable carefullly, the cable should be ok. What is the part number of your back plane?