Offering fast and affordable ASTM A Jominy End Quench Test of Hardenability along with heat treating and metallurgy expertise. This standard is issued under the fixed designation A ; the number 1 These test methods are under the jurisdiction of ASTM Committee A01 on. Steel. ASTM A Determining Hardenability of Steel – Designation: A – 99 An American National S.
|Published (Last):||23 January 2010|
|PDF File Size:||19.67 Mb|
|ePub File Size:||4.10 Mb|
|Price:||Free* [*Free Regsitration Required]|
When hardness readings are taken on two or more?
ASTM A255 PDF DOWNLOAD
It is astm a quantitatively, usually by noting the extent or depth of hardening of a standard size and shape of test specimen in a standardized astm a If the retest also has greater than 4 HRC points spread, a new specimen should be tested.
The use of these equations to plot curves may result in random asfm The procedure in preparing the specimen prior to hardness measurements is described in Sections 4, 5, and 6.
Asm first log in with a verified email before subscribing to alerts. The values given in parentheses are for information only.
The higher the carbon or alloy content, or both, the lower the boron factor. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided satm part of the standard.
The effects of phosphorous and sulfur are not considered since they tend to cancel one another.
In the end-quench test the depth of hardening is the distance along the specimen from the quenched end which correlates to a given hardness level. In the end-quench test the depth of hardening is the distance along the specimen from the quenched end which correlates to a given hardness level. The test consists of water quenching one end of a cylindrical test specimen 1.
Wash the sample in hot water. The test consists of water quenching one end of a cylindrical test specimen 1. The specimen shall be machined from a bar previously normalized in accordance with 6. Originally published as A — Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
The time between removal of the specimen from the furnace and the beginning of the quench should not be more than 5 s. The accuracy of this test method and the techniques used to develop it have been documented. The sample is then brought back up to austenitizing temperature as specified for alloy, adtm end quenched with a specialized holder for the end quench to occur.
ASTM A – The Jominy End Quench Test of Hardenability
An anvil providing a means of very accurately measuring the distance from the quenched end is essential. The sample shall be held at the temperature 2a55 in Table 1 for 1 h and cooled in air.
As the voice of the U.
This standard is also available to be included in Standards Subscriptions. Tempering of the normalized sample to improve machinability is permitted. A graphite or metal mold may be used to form an overlength specimen 1.
Your Alert Profile lists the documents that will be monitored.
Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters. For general statements regarding the use of test blocks and surface conditions, reference should be made to 4.
The two hardness surveys are made on adjacent?
ASTM A – 10() Standard Test Methods for Determining Hardenability of Steel
It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. The Certified Material Test Report shall state the method of hardenability determination. If the standard hardenability curve is needed, then the insert test specimen shown in Fig. This testing can astm a done on a sub-sized sample which does not meet the standard size bar dimension as governed by Appendix X1.
Referenced Astm a purchase separately The documents listed below are referenced within awtm subject standard but are not provided as part of the standard.